How do I troubleshoot my Samsung Blu Ray player?
Samsung Blu-ray player is not responding
- Remove the disc. Press the eject button on the Blu-ray player to open the tray and remove the disc, and then press eject again to close the tray.
- Reset the player to factory settings.
- Perform a firmware update.
How do I connect my Samsung Blu Ray remote to my TV?
Set up your Samsung universal remote
- Press the Home button on your TV remote to access the Home Screen.
- Press UP on the directional pad to access Universal Remote, and then select Universal Remote on the Source screen.
- Next, select Start and make sure the device you want to connect is turned on.
How do I reset my Samsung Blu Ray remote?
I called up Samsung and they walked me through a hard reset process, very simple. It worked for us: 1. Take out batteries from remote, point remote at blu ray player while holding down remote’s power button for 30 seconds. Then release.
What are the codes for a Samsung TV?
One-For-All remote codes
- 0587.
- 0060.
- 0019.
- 0056.
- 0093.
- 0030.
- 0178.
How do I pair my Samsung remote?
On most Samsung TVs, the remote control sensor is located on the lower right hand side of the TV. If not, it is directly in the bottom center. Next, press and hold the Return and Play/Pause buttons simultaneously for at least 3 seconds. Your TV will begin syncing with the Smart Remote.
What is the TV code for Samsung?
Second Method: Enter the TV code for Samsung : 0101, and keep trying with Samsung 4 digit and 5 digit remote code list below. The LED light will go off after the correct code is entered.
Why is my Samsung Blu-ray remote not working?
Unplug blu ray player power cable from power outlet for 30 seconds. 3. Plug power back in and put batteries back into remote (make sure batteries are still good). Should work, good luck.
Why is my Blu-ray player remote not working?
Remove the batteries from the remote control and press any of the buttons on the keypad to discharge any stored current. If possible, test the batteries to make sure both have sufficient charge or replace the batteries with new ones. Reinsert the batteries properly in the remote control.